There may come a time when you have issues with your plumbing, whether it’s a clogged sink or plugged up toilet. Check out the tips and suggestions in the article below that will show you easy things you can do on your own to solve these issues, and save a call to a plumber.
Never put fat, grease, or oils into your drain. These substances will clog the drain as they cool and harden. Even with a garbage disposal, you are going to cause it to be less efficient and risk drain backups. See to it that you dispose the oils away from your sink.
It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater’s instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.
To be successful in any plumbing project, make sure you turn the water off before you start unscrewing pipes. This tip might actually sound insulting, but you are probably getting caught up in having the right tools and parts and being dressed right. Double check that there is not a splash waiting for you. Then triple and quadruple check.
Treating your drains every month is a great way to avoid future clogs and other problems, and it’s a very simple procedure. Just run one to two gallons of hot tap water down each drain in your house.
As was shown in the above article, there are many plumbing issues that can be handled by someone other than a plumber. Once you take the time to read how to do it, you will be amazed at the things you will be doing without the expense of an expert.